Trans 205.02(10)
(10) “Resurfacing" means installing new or additional layers of surfacing on existing highway pavement to extend its service life for a substantial period of years and to enhance safety.
Trans 205.02(11)
(11) “Roadway" means the portion of a highway, including shoulders, for vehicular use.
Trans 205.02 Note
Note: Under this definition, a divided highway has 2 or more roadways.
Trans 205.02(12)
(12) “Shoulder" means that portion of a roadway that is contiguous to the traveled way and is used primarily for vehicle stopping in an emergency.
Trans 205.02(13)
(13) “Traveled way" means the portion of the roadway designed for movement of vehicles, exclusive of the shoulders.
Trans 205.02 History
History: Cr.
Register, December, 1986, No. 372, eff. 1-1-87; renum. (7) to (9) to be (11) to (13), cr. (7) to (10),
Register, February, 1992, No. 434, eff. 3-1-92; correction in (4) made under s.
13.92 (4) (b) 6., Stats., and renum. (4) to (6m) under s.
13.92 (4) (b) 1., Stats.,
Register February 2013 No. 686.
Trans 205.03(1)(1)
The design standards for urban county trunk highway improvement projects shall conform with the applicable department of transportation criteria, and, if applicable, with the federal criteria for the class of highway involved. The minimum design standards for rural county trunk highway improvement projects shall be as set forth below for each of the rural county trunk highway functional classifications. The functional classification for a particular rural county trunk highway segment shall be that shown for the segment on the most current department of transportation rural functional system map prepared under
ch. Trans 76 for local transportation aids purposes or, if applicable, on the most current federal aid system map.
Trans 205.03 Note
Note: Chapter Trans 76 was repealed.
Trans 205.03 History
History: Cr.
Register, December, 1986, No. 372, eff. 1-1-87.
Trans 205.035(1)(1)
The standards in s.
Trans 205.03 shall be used for all county trunk highway improvement projects, unless a region director expressly authorizes, in writing, the use of the department's “Design Criteria for Resurfacing, Restoration, and Rehabilitation Projects," also known as “3R" standards, for a resurfacing, restoration, or rehabilitation project on an existing highway located in his or her region.
Trans 205.035 Note
Note: Examples of improvement projects which may be appropriate for “3R" standards include resurfacing highway pavement; grinding and repairing pavement joints; replacing or recycling pavement; widening lanes and shoulders; replacing bridge elements to correct structural deficiencies; bridge deck overlays; and other related improvements such as minor incidental subgrade work and correction of minor drainage problems.
Trans 205.035(2)
(2) A region director may not authorize or approve the use of the department's “3R" standards for the construction of a new highway or for the complete reconstruction of an existing highway.
Trans 205.035(3)
(3) A request to use the department's “3R" standards in lieu of the standards in s.
Trans 205.03 may be submitted to a region director only by a county highway commissioner, or by a county highway commissioner's designee.
Trans 205.035(4)
(4) A region director shall grant or deny a request to use the department's “3R" standards within 90 days after receiving a request.
Trans 205.035(5)
(5) In determining whether to grant or deny a request to use the department's “3R" standards in lieu of the standards in s.
Trans 205.03, a region director shall consider all of the following:
Trans 205.035(5)(e)
(e) Social and economic impact, including dislocation or relocation of property owners.
Trans 205.035 History
History: Cr.
Register, February, 1992, No. 434, eff. 3-1-92.; corrections in (1) to (5) made under s.
13.92 (4) (b) 6., Stats.,
Register February 2013 No. 686.
Trans 205.04(1)(1)
After a region director has decided whether to use either the design standards in s.
Trans 205.03 or the alternative “3R" standards in s.
Trans 205.035, the regional director may expressly authorize, in writing, exceptions to either of these standards, if federal or state funds are not used for the improvement project.
Trans 205.04(2)
(2) Exceptions to either the design standards in ss.
Trans 205.03 or
205.035 for improvement projects using federal or state funds must be approved in writing by a regional engineer and, when federal funds are used, by the division administrator of the federal highway administration.
Trans 205.04(3)
(3) In determining whether to authorize exceptions to the construction standards in s.
Trans 205.03 or the alternative “3R" standards in s.
Trans 205.035, a region director shall consider all of the following:
Trans 205.04(3)(e)
(e) Social and economic impact, including dislocation or relocation of property owners.
Trans 205.04 Note
Note: “Exceptions to Standards" is located at the department's offices, in the Facilities Development Manual, procedure number 11-1-2.
Trans 205.04 History
History: Cr.
Register, December, 1986, No. 372, eff. 1-1-87; r. and recr.
Register, February, 1992, No. 434, eff. 3-1-92; correction in (1), (3) (intro.) made under s.
13.92 (4) (b) 6., Stats.,
Register February 2013 No. 686;
CR 22-048: am. (1) Register July 2023 No. 811, eff. 8-1-23.
Trans 205.05(1)(1)
On or before December 1 of each year, each county highway commissioner shall file with the appropriate region director a report for the county certifying that any and all county trunk highway improvement projects for which funds were expended or obligated during that year conformed to the minimum standards established under s.
84.01 (9) (b), Stats. The certification shall be on forms prescribed by the department of transportation. All county trunk highway improvement projects shall be reviewed by the region director for compliance with the standards stated in s.
Trans 205.03.
Trans 205.05(2)
(2) If any county has not complied with the standards, the region director shall notify the county in writing stating the items which are noncomplying. When the noncomplying projects have subsequently been made to comply with the standards, the region director shall certify compliance on forms designated for this purpose by the department of transportation. If on July 1 of any year there are in a county any remaining non-complying projects that have not been made to comply as certified by the region director, those projects shall be reported by the department of transportation to the appropriate legislative committees.
Trans 205.05 History
History: Cr.
Register, December, 1986, No. 372, eff. 1-1-87; corrections in (1), (2) made under s.
13.92 (4) (b) 6., Stats.,
Register February 2013 No. 686.
